EXAMPLE DATA: not for workshop use
Printed from Motrix. Every value, tool number and instruction is fictional. Volkswagen Golf VII · 1.2 TSI · 77 kW · engine CJZAExample
Fictional procedure: every value, tool number and instruction is example data. Never use it on a real vehicle.
Draining the cooling system, refilling with the specified coolant mix, and bleeding it.
DANGERPressurised hot coolant
WARNING
Draining the cooling system, refilling with the specified coolant mix, and bleeding it.
Fictional procedure: every value, tool number and instruction is example data. Never use it on a real vehicle.
Special tools
Workshop equipment
PartsNone
No parts to replace.
Torque referencesNone
No tightening values in this procedure.
Coolant
Document revision Rev. 01 · 2015-03
Place the collecting pan under the radiator. Release the lower hose clip and pull off the hose. Let the system drain.
Source: Example OEM Service · M-07.2
Refit the lower hose and secure the clip.
Source: Example OEM Service · M-07.3
Fill the system with the coolant mix from the Fluids page using the cooling system filling unit tool MX-T912 until the level reaches MAX.
Source: Example OEM Service · M-07.4
Run the engine at 2500 rpm for 4 minutes with the heater at maximum, then switch it off and let it cool. Top up to MAX only with the engine cold.
Source: Example OEM Service · M-07.5
With the engine cold, fit the tester adapter tool MX-T908 in place of the expansion tank cap and pressurise the system to 1.3 bar. The pressure must hold for 10 minutes, and no hose connection may leak.
Remove the tester, refit the cap and correct the coolant level. Refit the underbody panel.
Source: Example OEM Service · M-07.6
End of procedure · Rev. 01 · 2015-03 · fictional example data
Every source above is a fictional example record. Values in this procedure are example data.